Funkadelic's gallery / Car related / Audi S4 Mods / Brakes / APR Brakes - Install

APR Brakes - Install

tightening on the bolt-on bridge (5mm allen wrench) after installing the pads
SS braided brake line w/washers and bolt ready to go on
SS line connected to the caliper
breaker bar (or torque wrench in this case) used to loosen the 2-18mm bolts securing the stock caliper (instructions said 17mm).
Stock 321mm x 30mm (L) vs. APR 332mm x 32mm (R) rotor
Wow, now i need 355mm rotors!!!
abe.jpg
abf.jpg
plenty of clearance (1/4") on my 18x8.5" BBS CH's
Brake pad wear sensor connector...i chewed up the securing tab nicely
« previous
Page 2 of 5
next »
Powered by Gallery v2.3